Water coming through a ceiling means the main valve goes off first
If a pipe has burst or water is running where it shouldn't, find the main shut-off where the water line comes into the basement. It's usually on the front wall near the meter. Turn it clockwise until it stops, then open the lowest cold tap in the house so the lines drain. If water is near a light, an outlet or the electrical panel, stay clear of it. Only switch off the breaker if you can reach the panel while standing on a dry floor.
Move what you can, take photos for your insurer, and call. A burst pipe is an emergency plumber call. A slow drip under a sink can wait for a booked visit. Put a bowl under it in the meantime, and check that the cabinet floor isn't soaking up water.
Pipes on outside walls and outdoor taps are the ones that freeze
The 1991 to 2020 climate normals for the Vineland Rittenhouse station give a January mean daily minimum of -6.8 °C and a record low of -25.6 °C. That's cold enough to freeze a pipe running along an outside wall, under a kitchen sink on an exterior wall, in a crawlspace or through an unheated garage. The pipe often splits where you can't see it, and the leak only shows once it thaws.
Now is a good time to do the outdoor taps. Find the inside shut-off for each one, close it, then open the tap outside and leave it open so the trapped water can drain. If there's no inside shut-off, or the tap keeps dripping with the valve closed, get that small repair done before January. Frost-resistant taps that reach back through the wall help, but a hose left connected over the winter can still split one.
If a tap gives you nothing on a cold morning, the pipe is probably frozen. Shut off the main, open the tap, and warm the area gently with a hair dryer or by leaving the cabinet doors open. Never use an open flame. If you can't find the frozen spot, or the pipe has already split, call us.
Low pressure and pinhole leaks in older houses usually mean galvanized pipe
Many of the houses in Beamsville, Jordan, Jordan Station and Rittenhouse Park built before 1945 still have galvanized steel water pipe. It rusts from the inside and the opening slowly narrows. The upstairs shower goes weak, and the kitchen tap runs brown after you've been away a few days. In the end it leaks through small pinholes, often at the threaded joints.
You can check this yourself. Galvanized pipe is dull grey, a magnet sticks to it and the joints are threaded. To fix a single pinhole leak, we cut out a short piece and put in new pipe, and that repair will hold. It won't bring back the pressure, though, because the rest of the line is closing up the same way. If the pressure is poor all through the house, the repair that lasts is replacing the galvanized runs, starting with the main line from the meter. We'll show you which sections are worst so you can do the work in stages if you'd like.
Most of the houses built in Vineland and Beamsville from the 1950s to the 1970s have copper water pipe, and it has held up well. Leaks in those houses usually come from a fitting, a shut-off valve or an old joint, not the pipe itself. The new houses at Prudhommes are plumbed in PEX, so when something goes wrong there it's usually a fitting or a fixture, not worn-out pipe.
Lead and layered plastic pipe are worth finding before they cause trouble
Lead pipe is dull grey and soft enough to scratch shiny with a key, and a magnet won't stick to it. If you find it on the line coming into the house, or you aren't sure, a water test will tell you more than guessing. Ontario's drinking water standard for lead is 0.010 milligrams per litre. Until the pipe is replaced, run the cold tap until it feels noticeably colder before drinking water that has sat overnight, and cook with cold water, not hot.
Some houses were plumbed with a layered plastic and aluminium pipe, usually orange for hot and blue for cold, joined with brass fittings. Those fittings can corrode and give way without warning. You can often spot this pipe at the water heater or under a sink. If you have it, plan to replace it now instead of waiting for a leak. We'll tell you how much of the house it runs through.
Dripping taps and running toilets are usually a simple fix
A toilet that refills on its own between flushes is losing water past the flapper or the fill valve. Put a few drops of food colouring in the tank and wait. If colour shows up in the bowl without a flush, the flapper is leaking. Both parts are routine to replace, and that repair will hold. A toilet that rocks, or leaves water around its base, needs a new wax seal and sometimes a new flange. Don't leave that one, because the water ends up in the subfloor.
A dripping tap needs a new cartridge or washer. If the faucet is old and parts are worn or hard to find, we'll tell you whether a new faucet makes more sense than hunting for parts. Part of Lincoln gets its water from Niagara Region's Grimsby plant, which listed its hardness at 126 mg/L in October 2025. The scale from water that hard wears out cartridges and clogs aerators sooner.
A repair visit starts with finding the cause, then a written price
First we ask what you've noticed and when it started. Then we look at the pipe, fitting or fixture to find where the water is really coming from, which isn't always where it shows. You get the price in writing and approve it before any part goes in. If a repair will hold, we say so. If the pipe around it won't, we show you why and give you both options.
Work is performed by licensed plumbers (306A Certificate of Qualification). New plumbing and changes to drains generally need a building permit, and the Town's building department decides whether a given job does. If we think yours might need one, we'll tell you before we start.
If a leak has run into the floor drain or the drains are slow as well, see drain cleaning. Common questions about old pipe and frozen lines are answered in the FAQ.
