Rising water at the sump or a pump that won't stop comes first
If water is rising in the pit and the pump is silent, or water is already on the basement floor, start with the simple checks. Is the pump plugged in? Has the breaker or the GFCI outlet tripped? Is the float stuck against the side of the pit? If the pump still won't start and the water keeps coming, move what you can off the floor and call. Treat that as an emergency call.
Other faults give you more warning. Watch for a pump that cycles every minute or two in dry weather, or one that runs and runs without the water level dropping. A grinding or rattling motor is another sign, and so is a loud thump in the pipe when the pump shuts off. Each of these means a part is wearing out, and it's better found on a dry day than in a storm.
A power cut in a storm is the main risk for newer houses
The houses at Prudhommes, off North Service Road east of Victoria Avenue North, have PEX water pipe and plastic drains that won't give trouble for a long time. What they depend on is the sump pump. The foundation drain around the basement runs to the pit, and the pump lifts that water out. If the pump fails or the power goes out, the water has nowhere to go but up through the pit.
On July 21, 2026, Lincoln got more than 110 mm of rain in just over an hour. Rain like that is when the pump has the most work to do, and it's also when a storm is likely to knock out the power. A battery backup is a second pump in the same pit, running on its own battery. It takes over when the main pump stops or can't keep up. We set its float a little higher than the main pump's so the two don't fight, and show you where the alarm and the battery test are. There's more on choosing one in our guide, does a sump pump need a battery backup.
You can test the pump yourself before the next heavy rain
Unplug the pump, lift the lid and clear any gravel or debris from the bottom of the pit. Plug it back in and slowly pour a pail of water into the pit. The float should rise, the pump should start, empty the pit quickly and shut off cleanly. Then go outside and check that water came out the end of the discharge pipe, away from the house.
If the pump hums but nothing moves, starts late, or the water runs back into the pit after it stops, call before the next storm, not during it. A test in spring and another in fall, plus one after a long dry spell, catches most problems early.
A repair holds when the fault is the switch, the valve or the line
Plenty of sump pump faults come down to small parts. It might be a float switch that sticks, a check valve that no longer closes and lets water run back into the pit, or a discharge line that has come loose or clogged. Replace the part and the pump carries on. When a repair will hold, we tell you so.
When the motor itself is failing, the pump overheats, or the housing is cracked and rusted, a new switch won't buy much time. That's when replacing the pump makes sense. We size the new one to how much water your pit takes in, not just to the label on the old one.
Some older houses have no sump at all. Putting one in means breaking the floor for a pit and changing where the foundation drain goes. That generally needs a building permit, and the Town's building department will tell you whether yours does.
Where the water goes matters as much as the pump
The discharge should go outside, onto the ground and away from the foundation, never into the sanitary sewer. In Beamsville's Ontario Street sewershed, the Town has been tracking stormwater that reaches the sanitary sewer through downspouts and sump pumps connected to it. That water fills the pipes on the same wet nights when everyone's basement is at risk. If your pump empties into a floor drain or a laundry tub, ask us to look at it.
Winter brings a different problem. At the Vineland station, the January mean daily minimum is -6.8 °C and the record low is -25.6 °C. A discharge line that stays full of water outside can freeze solid, and then the pump is pushing against ice. We slope the outside line so it drains between cycles and protect the outlet where it's exposed.
Many 1950s to 1970s houses in Vineland and Beamsville have their foundation drains tied straight into the sewer, with no pump at all. In those houses, basement backups in heavy rain are the bigger worry. A backwater valve is the place to start, and the Town offers a subsidy toward one. In St. Catharines, the City reimburses eligible owners of older homes for most of the cost of a backwater valve, moving the weeping tile to a sump pit and a backup pump. See St. Catharines for that.
How a sump pump visit goes
We ask what the pump has been doing and since when. Then we test it with water in the pit and check the float, the check valve, the wiring and where the discharge ends up. You get a written price before any part is fitted. If a repair will keep the pump going, you hear that before anyone talks about a new one. Work is performed by licensed plumbers (306A Certificate of Qualification).
If you'd rather plan a replacement or a battery backup ahead of spring, ask for a quote.
