Water coming up through the floor drain is the one to call about now
If dirty water rises through the basement floor drain, or shows up in the downstairs shower or toilet when someone upstairs runs a tap, the main line is blocked. Everything the house sends down has nowhere to go but up. Stop running water: no laundry, no dishwasher, no flushing. That water is sewage, so keep children and pets away from it. If it is near an outlet or the furnace, turn off that breaker, but only if you can reach the panel without standing in water.
Then call an emergency plumber. This one shouldn't wait for the weekend. Heavy rain makes it more likely. On July 21, 2026 Lincoln got more than 110 mm of rain in just over an hour, and the Town notes that rain like that can be more than drainage systems can carry. Houses from the 1950s to 1970s often have foundation drains tied by gravity into the sewer, so they tend to feel it first.
Several slow drains at once point to the main line
One drain on its own is usually a local clog. When the tub, the bathroom sink and the toilet all slow down together, the blockage is further down, in the line they all share. The same goes for a toilet that gurgles, or whose water level jumps, when the washing machine empties.
You can check this yourself. Run the kitchen tap for a minute and watch the basement floor drain. If water comes up there, turn the tap off and call. A main line that drains slowly will not clear itself. It usually gets slower until the day it backs up.
A single slow sink is usually close to the fixture
In a kitchen it is grease and food scraps that have set in the trap or in the pipe behind the wall. In a bathroom it is hair and soap caught at the stopper. With a toilet it is often something that should not have been flushed, like wipes, a small toy or too much paper at once.
Some of this you can deal with yourself. Pull out the bathroom stopper and clear the hair off it. Use a flanged plunger on a toilet and a flat one on a sink, with a few centimetres of water in the bowl or basin so it seals. If two good tries don't move it, or the same drain slows down again within a week or two, the blockage is past where a plunger reaches, and the line needs to be cleared properly.
Roots find the joints in Lincoln's older clay sewers
Houses built before 1945 in Beamsville, Jordan, Jordan Station and Rittenhouse Park usually drain through cast iron inside the house to a clay tile sewer under the front yard. The 1950s to 1970s houses in Vineland and Beamsville often have a clay or fibre sewer pipe running to the street. Both kinds of pipe have joints, and tree roots grow into those joints looking for water. A cable cuts the roots out and the drain runs again, but the roots are still in the joint and they grow back.
If the line blocked once, with grease or a flushed wipe, clearing it is the whole job and it will hold. If the cable brings back roots, or this is the second or third backup in a year, we clear the line and then put a camera down. We show you what is there. It might be a few roots at one joint, a cracked section, or pipe that has sagged or started to collapse. Then you decide whether to have it cleared on a schedule or to look at sewer repair.
In Lincoln the owner is responsible for the private sewer from the property line to the house. If there is no suitable clean-out, the homeowner pays to clear a blockage wherever it turns out to be, and that matters most when the cause is roots or grease. If you don't know where your clean-out is, we can look for it while we are there.
Newer houses at Prudhommes block for different reasons
The houses going up at Prudhommes, on North Service Road east of Victoria Avenue North, have plastic drains and a PVC sewer, so roots and worn-out pipe are rarely the problem. Clogs in these houses are mostly at the fixture: grease in the kitchen line, hair in the shower drain, wipes in a toilet.
The bigger risk in a new house is water that never reaches a drain at all. The foundation drain runs to a sump pump, and if that pump stops or loses power in a storm, the basement floods. If there is water on the floor but every drain is running normally, check the sump pump first.
How a drain visit goes, from snake to camera
We start with a few questions. Which drains are slow, and since when? Does it happen after rain, or after the washer runs? Then we find the closest way into the line, which might be the trap, a clean-out or the toilet, and choose the tool. A snake is a turning steel cable that breaks up a soft blockage or cuts through roots. A water jet scours grease and sludge off the inside of the pipe, which helps a kitchen line that keeps closing up. You see the price in writing and approve it before any work starts.
If the camera finds a section that has to be dug up, we explain what that involves before anything else happens. A locate has to be requested through Ontario Dig Authority before any digging. Those public locates don't mark private lines like your own sewer, so the camera footage is how you know what is down there. Replacing a section of drain changes your plumbing, and changes to drains generally need a building permit. The municipal building department says whether a given job does.
Work is performed by licensed plumbers (306A Certificate of Qualification).
